Griplock™ cylinder band setup – Aqua Lung WTX-D Buoyancy System User Manual
Page 29
Table of Contents
© 2014 Apeks
A
B
C
Macro Presets
Threading the GripLock™ Cylinder Band
Adjusting the GripLock™ Cylinder Band
NOTE:
The GripLock™ cylinder band adjusts for all standard cylinder diameters and is ready
for use with an aluminum 80 cf (7.25 inch / 184 mm) cylinder when it leaves the factory.
WARNING:
The buoyancy cell must be completely deflated of air before adjusting the
GripLock™ cylinder band. Failure to do so may result in the cylinder slipping during the
course of a dive.
There are three diameter settings for cylinder size A. large cylinder B. AL 80 cf (7.25 in / 18.5 cm)
C. smaller cylinder. Adjust the macro adjustment for the proper size cylinder. Secure hook and loop
after cylinder size is selected.
Insert the open end of the cylinder band into the large opening of the bail, around the slide bar and out
the small opening of the bail. Secure the hook and loop on the band to hold the bail in place.
GRIPLOCK™ CYLINDER BAND SETUP