Aquatic AV AQ-DM-3B - Manual (Page 3)

GETTING STARTED
3
www.aquaticav.com
The AQ-DM-3B includes the universal harness AQ-UNH-2 in order to connect the dock
to power and speakers.
All open wire connections should be soldered and protected against water and dust for
best long term performance.
AQ-DM-3B
1. Mounting templates are included. Aquatic
AV recommends using the ‘measure twice, cut
once’ method.
2.
Once the mounting hole is complete, make
sure the outside surface is clean and clear
of debris. The Digital Media Locker has an
external water/dust proof gasket, but this
requires a clean surface for best performance.
3.
The Digital Media Locker has six (6) front
screws. Drive the screws using a screw driver.
During final mounting apply equal pressure
to all points for the best water/dust outer seal
performance.
4.
Review all outside surfaces of the Digital
Media Locker to ensure proper water/dust seal.
This is important for long term environmental
protection performance for your digital media
device.
12-PIN HARNESS CONNECTION
MOUNTINg THE UNIT
180mm 151mm
82mm 140mm
58mm
91mm
mute
2 Ohm
No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
Locker.
Make sure the polarity of speakers are
connected correctly.
2 Ohm
2 Ohm
2 Ohm
(White/strip)
Not connected (7)