Aquatic AV AQ-AC200-2 - Manual (Page 3)

DESCRIPTION
The Aquatic AV AQ AC200.2 two-channel amplifier provides 2x70 watts of
power into a 4 ohm load and 2x110 watts of power into a 2 ohm load. This full
featured model is an excellent choice for a variety of marine audio sound
system configurations.
The AQ AC200.2 uses an unregulated MOSFET power supply for superior
control of output wattage. A toroid-coil transformer yields maximum power
transfer with minimum heat loss. Careful attention to circuit design keeps AM
RFI at low levels, so you won’t hear unwanted noise when the level is cranked
up. Protection circuits safeguard the amplifier when overheating and speaker
shorts or improper load conditions occur.
All connections and controls of the AQ AC200.2 are on the end panels and are
easy to understand. We use gold-plated RCA and barrier connectors to ensure
the best electrical connection for your system.Included is an external
automotive type fuse that is easy to replace.
INPUT CONNECTIONS AND AUDIO CONTROLS
The front panel of the AQ AC200.2 contains connections for RCA Inputs and
Audio Controls as shown below.
The RCA Input Connections are gold-plated RCA Jacks and are labeled as
RIGHT and LEFT.
1
D
E
S
C
R
IP
T
IO
N
12 3 4 5 6 7
1. RCA Input Jacks
2. Gain Control
3. Bass Boost Control
4. Freq (Hz) Selection Control
5. Crossover Frequency Multiplier Switch
6. X-Over Mode Switch
7. Input Select Switch
Figure 1-