ARAG Navigator LT - Manual (Page 19)

19
ADVANCED SETTINGS "IMPLEMENT"
*
Fig. 65 Fig. 66
• Implement rear view
- Confirm by pressing OK to enter setup.
- Enter the value.
* Implement width
Implement width
Boom width
(sprayed area)
14.00 m
20.00 m
Fig. 67
The width set for the implement is shown on the display in the guidance screen: usually it is
equal to the boom width, and thus to the covered area diagram.
If you wish to see two different widths displayed on the guidance screen, as in the example
of Fig. 67, set the
Implement width to a different value than the boom width (par. 10.1.1).
END 10.1.3 Towed implement geometry settings (SYSTEM WITH 3-POINT HITCH REAR/FRONT)
> > > 10.1.3 Towed implement geometry settings (SYSTEM WITH 3-POINT HITCH REAR/FRONT)
Par.
7.4
Exit the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Data
increase /
decrease Scroll
(UP /
DOWN) Enter
selected
character