Atlantic Water Gardens TidalWave Pump Protector - Manual (Page 3)

Installation Instructions:
1. Attach the mounting plate to the back of the Pump Protector with
the four screws provided.
2. Choose a spot near the GFCI outlet to mount the Pump Protector.
3. Attach the Pump Protector to a post or structure using two exterior
screws (not included).
Note: Make sure that the Pump Protector is high enough that the Pump Power Supply
Cord ( figure 1) is not lying on the ground. The Pump Protector can either be mounted
horizontally or vertically.
To Improve The Reliability of Your Pump Protecting System:
1. Provide adequate wiring to the Pump Protector to ensure that load
switching from other appliances do not change line voltatge more
than 10% during abrupt load changes.
2. Calibrate the Pump Protector only after verification that the pump
liquid flow is adequate.
3. Connect only one pump to the Pump Protector.
4. Regularly check the conveyance system for slow build up of
deposits that can affect water flow over time.
5. Some pumps inherently have cavitation due to pump design and
may intermittently shut down.
FIGURE 1
Controller Unit
Power Supply Cord
Pump Power
Supply Cord
Reset Button
Controller Unit