Atlantic Water Gardens A-05 - Manual (Page 8)

Problem Possible Cause Possible Solution
Pump does
not start
Power is off Turn power on
Power failure
Check power supply or
contact local power company
Voltage drop/
Overload Check/Replace the GFI (Ground
Fault Interrupter)
Power cord is not
connected
Connect power cord
Pump stops after
starting
Pump is
overheating Submerge pump/Raise water level/
Allow pump to cool
Power/Current
overload Check length/size of power cable.
Check or replace GFI
Impeller is blocked
Remove debris from the
impeller chamber
Diminished
flow rate or
no water flow
Air lock Restart/Clean air valve
Obstruction in pump
or piping
Clear obstruction
Piping is too long Reduce length of pipe
Troubleshooting Guide
Always turn off power before inspecting the pump. Failure to observe this
precaution can result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If
the problem persists, contact your dealer.
8