Eneo HDC-2080CS D - Manual (Page 15)

15
EN
Installation instructions
CAUTION: The camera’s base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
• Make sure the power is removed before the installation.
• Follow the order for applying power.
First connect the low voltage (DC12V or AC24V), then plug the AC adapter to AC outlets
to avoid an improper reset from power jitter and a damage from the surge voltage when
no load.
1. Remove the dust protection cap from the lens mount.
2. Screw the lens onto the camera firmly.
3. Plug the lens plug into the lens connector on the rear of camera case.
4. Mount the camera to the wall or ceilling with a corresponding mounting bracket
through the camera mount holes (1/4" thread insert) on its top or bottom.
CAUTION:
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.
Setting the back focus adjustment
The proper back focus adjustment is essential for the motorized zoom lens to get the all
time sharp focus when zooming in and out by the remote control. For easier and better
adjustment, this camera provides FOCUS ASSIST menu which prevents from the mistake
of the focus adjustment.
With enabling FOCUS ASSIST menu, follow the procedure to get the best back focus
adjustment.
1. Set the lens for the zoom position to WIDE and the focus position to INFINITE(∞).
2. Shoot the object departing from about 10 meters.
3. Adjust ’Back focus adjustment with Torque wrench’ until the optimum focus is
achieved.