Eneo VKCD-1329ASFM - Manual

CCTV MINI VANDAL DOME CAMERA
700TVL High Resolution Mini Dome Camera
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral
triangle is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
Regulatory Notice
CAUTION : To prevent electric shock and risk of fire hazards:
Do NOT use other than specified power source.
Do NOT expose this appliance to rain or moisture.
WARNING - Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and use in accordance with the instructions, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause interference, in which case the user will be required to correct the interference at
his own expense.
This color video camera is designed for use in monitoring systems.
- IP66 Rating, Aluminum Die-casting Rugged Vandal proof Camera (Surface mount)
- 1/3” 520K Color IT-CCD
- Digital Clamp (with Anti-smear)
- ACE(Digital WDR)
- De-Fog
- Edge Adaptive 2-D Digital Noise Reducer
- Electronic IRIS
- Enhanced Y/C Separator (De-Mosaic, De-Moiré)
DC12V
50
Power and Video connection
OSD Control Key(optional)
Specifications
Yellow, Video output
Red, Power input
L
DOWN UP
R
CAMERA Power(12V), Video
Surface mount Flush mount
Unpacking
Below items should be included with the camera.
Please check the items before use.
Surface Mount
Flush Mount
Optional cable:
Manual Camera Installation Screws L-wrench Set Screw
L-wrench Set Screw Manual Camera Installation Screws Ceiling processing sticker
Ceiling processing sticker Ø67
67mm Center/Centre/Centro
Mittelpunkt
To be symmetrically placed
from the center A placer symetriquenent par
rapport au centre
instalar simetricamente a la
perforcion del techo
Symetrisch am
Mittelpunkt ausrichten
Center Ø67
Optional joystick cable to
set OSD menu
Specifications are subject to without notice.
Signal Format
Image Device
Resolution
Total Pixels
Effective Pixels
Shutter Speed
Sync. System
S/N Ratio
Iris Control
Video Output
Temperature
Power supply
Humidity
Power Consumption 1/3＂ 520K Color IT-CCD
700 TV Lines
Internal
More Than 50dB
Electronic
Composite ( 1.0Vp-p/75 Ohm )
-10℃ ~ +50℃
DC 12V(±10%)
RH 85% MAX
Max.1.5W
607K pixels
568K pixels
1/50 ~ 120,000sec
VKCD-1329ASxM
① Fix the BASE HOUSING to the desired
place with screws supplied.
② Adjust desired scene by turning and
moving the CAMERA BRACKET.
③ Put the DOME COVER over the BASE
HOUSING and turn it clockwise
by hand.
④ To fix DOME COVER tight, use SET
SCREW.
① Use “Ceiling processing sticker” on
the desired place to install camera
and make a hole on that place.
② Place the BASE HOUSING on the
hole and fix it with screws supplied.
③ Adjust desired scene by turning and
moving the CAMERA BRACKET.
④ Put the DOME COVER over the BASE
HOUSING and turn it clockwise by
hand.
Surface Mount Flush Mount
BASE HOUSING
CAMERA BRACKET
STOPPER RING DECORATION RING
DOME COVER
SET SCREW
SCREW
Camera Structure
BASE HOUSING
CAMERA BRACKET-BOTTOM
SUPPORT
CAMERA AAS’Y
CAMERA BRACKET-TOP
SCREW
Sureface Type Flush Type
Dimensions(mm)
60.50
37.00
Ø57.00 Ø80.00
58.50
Ø88.00 Ø57.00
Ø3.90
3-Ø3.90
Ø67.00
B.C.DØ72.00
Video Out GND
Power(+)
GND