Eneo EDC-IDFSW - Manual (Page 10)

0
3. Mounting the Wall Mounted and Ceiling Suspended Housing
1. Attach a mount on the ceiling or the wall using tapping screws (ceiling mount: M6, wall mount: M8, power box: M6) and plastic bushings.
CAUTION: For safety, the structure that a mounting base is installed on should be strong enough to support a minimum of 25kg.
For safety, a mounting base should be strong enough to support a minimum of 9kg.
2. Wind Teflon tape around the screw thread „A” of the pipe (respectively approx. 0 wraps). See fig. 
3. Push all required cables through PG (4).
4. Screw the screw thread „A” wrapped in Teflon tape into the mount until firmly in place.
5. Connect the power connector of 4VAC of the cables to „AC IN” of fan & heater board (3).
6. Connect the power, the alarm and the communication lines in the cables to the connectors of the Base Board of the Dome Camera.
7. Fasten the Dome Base on the screw spacer (8) usig 3 screws (M4xL8).
8. Attach the Dome Body to the Dome Base.
After aligning the arrow mark of the Dome Base with the unlock mark of the Dome Body, turn the Dome Body to the lock mark direction.
NOTE: It is recommended, not to assembly the dome enclosed with the camera and to remove the window in front of the lens
(refer to fig. 2).
9. Insert the rubber gasket (7) into the body (6) and fasten the bubble ring () to the body (6) using 3 screws (3).
„A”
seal with Teflon tape
Fig. 1
Fig. 3: Fan & Heater Board Diagram
Fn. : RELAY
COM NO
HEA
TER
FAN
Fn.

: JUMP

FUNCTION
JUMP1: Join JUMP each other to operate the Fan continuously irrspective of
temperature changes.
RELAY: Connect the Alarm OUT (Relay) of a Dome to this Relay to work the Heater
irrespective of temperature changes. (ex. after connecting RC and NO of a
Dome to this Relay, turn on the Alarm OUT in the Dome (Heater ON).)
Fig. 2: Remove the window and the bubble ring ass’y
push
push
Remove window
Bubble
Srew