Enviracaire 60000 - Manual (Page 3)

Fig. 6
Vacuum
Attachment
CLEANING THE PRE-FILTER
The particle pre-filter helps pick-up large airborne particles that enter the rear grille. This
pre-filter can be removed and rinsed by hand under warm water. Let the pre-filter dry
completely
before inserting it back into the unit.
REMOVING / CLEANING THE IFD FILTER
To remove the IFD filter:
• Turn the Control Knob to the OFF
position and UNPLUG the air purifier.
• Pull the notch to release the rear grille
(Fig. 4).
• Remove the rear grille.
• Gently pull the IFD Filter out of its
housing by grasping the center of the
filter and pulling towards you (Fig. 5).
To clean the IFD filter:
• DO NOT USE WATER OR OTHER
LIQUIDS TO CLEAN THE IFD FILTER.
• After removing the IFD Filter from the air
purifier, gently tap the filter onto a firm
surface within a trash receptacle to
release the captured particles.
• To vacuum-clean the filter, lay the filter
on a flat surface and run a vacuum
cleaner with a nozzle or brush
attachment along the filter to pick-up dirt
(Fig. 6).
Fig. 4
INSTALLING THE FILTERS
Please make certain that the Control
Knob is in the OFF position and the air
purifier is unplugged.
To install the IFD Filter and pre-filter:
• Hold the filter with the top arrows
pointing up ( ) and the insert arrows
pointing towards the unit( ) (Fig. 3).
• Gently insert the filter into the filter
compartment.
• Make certain that the filter is secure in
the unit.
• Place the pre-filter inside the rear grille
and snap into place.
Fig. 5
If the IFD Filter clogs or you have difficulty cleaning the filter, please visit our website at
www.kaz.com
or call us at 1-800-332-1110.
Fig. 3
IFD Filter Pre-Filter
035-00456-000_R0 60000 10/7/03 12:34 PM Page 3