Installation, Cabling, Installation 8 – Ensemble Designs 7110 HD/SD/ASI Reclocking Distribution Amplifier User Manual
Page 8: Cabling 8
www.ensembledesigns.com
Page 8
Model 7110 HD/SD/ASI and Model 9110 3G/HD/SD/ASI Reclocking DA
Installation
Plug the 7110 or 9110 modules into any one of the slots in the 3RU or 1RU frame and install the plastic
overlay provided onto the corresponding group of rear BNC connectors associated with the module
location. Note that the plastic overlay has an optional adhesive backing for securing it to the frame.
Use of the adhesive backing is only necessary if you would like the location to be permanent and is not
recommended if you need to change module locations. These modules may be hot-swapped (inserted
or removed) without powering down or disturbing performance of the other modules in the system.
Cabling
Refer to the 3RU and 1RU backplane diagrams of the module below for cabling instructions. Note that
unless stated otherwise, the 1RU cabling explanations are identical to those given in the 3RU diagram.