H3C Technologies H3C S5560 Series Switches - Manual (Page 12)

7
IMPORTANT:
•
To remove the filler panel (if any) from the power module slot on
the device, insert a flat-blade screwdriver through the handle and
pull the filler panel outward along the guide rails, as shown
in
Figure 4 .
• When you insert the power module into the slot, you can do that
through slight inertia so that the terminals of the power module
can have a good touch with the backplane.
• To avoid damaging or bending the terminals of the power
module, if the insertion direction is improper during the
installation, you must pull the power module out, adjust the
direction, and insert it again.
• Keep the filler panel and the packaging box and packaging bag
of the power module for future use.