Eurotech Appliances EDV278EL - Manual (Page 11)

1 1
ENGLISHENGLISHENGLISHENGLISHENGLISH
ANTI-CREASE
At then end of a program, if the knob is not turned to the 12:00
position or the door is not opened, the Anti-crease function begins.
This means that the drum rotates the clothes once every minute
to prevent creases from setting in. The Anti-crease and end-of-
program tone continue until you turn the program knob to the 12:00
position or open the door to remove the laundry.
ADDING AN ITEM
If you wish to interrupt a program to add or remove an item from
the dryer, simply open the door. The dryer will stop and the heating
element will shut off. After you have inserted the additional item(s)
into the dryer, close the door, wait for the beep, then press Start.
CHANGING A PROGRAM
If you decide to change the program setting after you have started the machine, simply turn the program
knob to the 12:00 position and wait for abeep. After the beep, turn the program knob to the desired program.
After a second beep, press Start.
Fabric Type Program
Temp
Setting
Load
Size
Heavy cottons and denims Extra Dry Normal Full
Cottons and linens w/out elastic and/or decorative
trim, white and colorfast items Normal Normal Full
Fabric Type Program
Temp
Setting
Load
Size
White and colorfast perma press Normal Delicate Half
White and colorfast items that require ironing Iron Dry Delicate Half
Polyester/acrylic blends, rayon, acetate Damp Dry Delicate Half
Washable silk and nylon Damp Dry Delicate Third
Fabric Type Program
Temp
Setting
Load
Size
Heavy cottons and denims 60' Normal Full
Cottons and linens w/out elastic and/or decorative
trim, white and colorfast items 40' Normal Full
White and colorfast perma press 40' Delicate Half
White and colorfast items that require ironing 20' Delicate Half
Polyester/acrylic blends, rayon, acetate 20' Delicate Half
Washable silk and nylon 20' Delicate Third
Timed
Synthetics
Cottons/Linens
RECOMMENDED PROGRAMS
AND TEMPERATURE SETTINGS
The table below is intended to help you determine which program is best for each type of load.