Grass Valley 2000GEN - Manual (Page 7)

2000GEN Instruction Manual 7
Installation
Cabling
Cabling to the 2000GEN module is done on the BNCs on the rear of the
frame. Refer to
Figure 2 for a detailed illustration of the rear connections
referenced below.
Reference Inputs
The 2000GEN will accept any of the video standards listed in the Input
specifications in
Table 1 on page 17 . Connect a video input to the Reference
BNC. In the 3 RU frame, terminate the looping connector if the signal is not
looped to other equipment.
Figure 2. 2000GEN Input Connectors
Media section
rear slots 1-6
Media section
rear slots 7-12
Power, frame
configuration,
& frame health
connections
8172-07
Reference
Loopthrough Input
J101
1
2
3
4
J102
8172-06 Media section
rear slots 1-2
Media section
rear slots 3-4
Terminating
Reference
Input
Power connections
3 RU Frame
1 RU Frame