Grass Valley 8900NET v.4.0.0 - Manual (Page 39)

8900NET Instruction Manual 39
Using the 8900NET GUI
SNMP Reporting Web Page
Selecting the SNMP Reporting web page link from the Frame link list or the
Frame SNMP Reporting link from the Configuration web page will bring
up the web page shown in
Figure 19 on page 40 . When an SNMP Managers
such as Thomson Grass Valley’s NetCentral is installed, SNMP trap
reporting from the frame and modules can be configured using these con-
trols.
• Trap Destinations – selecting the Trap Destinations link from this web page
will bring up the 8900NET Configuration web page explained and
shown in
Figure 25 on page 47 .
• Hardware Switch Status – the Hardware Switch Status section of this web
page displays the current settings of the DIP switches, S1 and S2, on the
8900NET circuit board as described in
8900NET Module Alarm DIP
Switches on page 20 . These switches allow enabling and disabling of
what status reporting information is provided to the Frame Alarm and
SNMP traps.
• SNMP Trap Reporting – enable or disable SNMP Trap Alarm and Warning
reporting for the following functions in the frame:
• Media module (Slots 1-10) fault alarms, and removed, loss of signal,
loss of reference, and configuration error warnings (as specified for
each specific module),
• 8900NET module fault reporting,
• Power supply 1 and 2 fault reporting,
• Frame Bus status fault reporting,
• Fan (in front cover) Status fault reporting,
• Module health fault reporting (8900TF)
Use
this
link