Grass Valley RCP2050 - Manual (Page 20)

16
CopperHead RCP 2050 Features
Controls
Controls
The following descriptions indicate the full potential control of the CHRCP-2050A but do
NOT imply that all controls are available for any particular control panel emulation.
Cameras and controllers differ considerably in the functionality they offer. Refer to
Emulation and Control Features on page 23 for available control features.
All camera settings and adjustments must be read with reference to the emulated control
panel and specific camera manuals.
Variable Adjust Buttons
The variable adjust buttons along the unit's left side allow digital bit increment and
decrement of the parameter selected with the rotary encoder. A flashing illuminated
variable button means that the rotary encoder is active for this item. The 'adjust' LED should
be illuminated. The variable value is shown on the OSD. A steady illuminated variable
button means the parameter value previously varied is now fixed and operational.
To adjust a parameter, select by pressing the appropriate button once. The button will flash
if the parameter is available. The camera will be updated with the value associated with the
parameter and adjustment can be made.
• A flashing illuminated variable button means someone is using the rotary encoder to
change its setting. The dual mode GAIN display indicates the variable value with an
inverted display.
• A steady illuminated variable button means the parameter value is fixed and
operational.
• If the button is pushed, again the LED will extinguish and the previous parameter value
will be reinstated. To retain the adjusted value, leave the LEDs on.
• If another parameter adjustment is required, press the appropriate button. The
previous button will go to steady illumination indicating that its particular value has
been retained and the new button will flash indicating the new parameter adjustment
active.
• To switch off a previously fixed parameter, press its button twice. Once will force the
parameter adjustment active and the second will turn it off.