Extreme Networks BlackDiamond 12804 - Manual (Page 117)

Replacing a BlackDiamond 12804 PSU/Fan Controller
BlackDiamond 12800 Series Switches Hardware Installation Guide 117
Figure 74: Removing the BlackDiamond 12804 PSU/Fan Controller
6 Using a #1 Phillips screwdriver, loosen all four captive screws on the PSU/fan controller (see
Figure 74 ).
7 Pull equally on the upper and lower handles of the PSU/fan controller to disconnect the controller
connector.
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always
available when you need to handle ESD-sensitive components.
Installing a Replacement BlackDiamond 12804 PSU/Fan
Controller
To install a replacement PSU/fan controller in the BlackDiamond 12804 switch:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the front top-left corner of the switch.
2 Align the guide pins in the empty controller recess with the holes on the replacement PSU/fan
controller.
3 Push the replacement BlackDiamond 12804 PSU/fan controller into the empty controller recess until
the four captive screws on the replacement controller are in alignment.
4 Using a #1 Phillips screwdriver, tighten all four captive screws on the replacement controller.
5 Align the guide pins on the access cover with the holes at the edges of the controller recess.
6 Push the access cover over the controller recess until the eight captive screws on the access cover are
in alignment.
7 Using a #2 Phillips screwdriver, tighten all eight captive screws on the access cover.
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always
available when you need to handle ESD-sensitive components.
BD_170