Extreme Networks BlackDiamond 12804 - Manual (Page 122)

Replacing BlackDiamond 12800 Series Chassis Components
BlackDiamond 12800 Series Switches Hardware Installation Guide 122
Pre-installation Requirements
You must have access to the back of the BlackDiamond 12802 switch to replace the fan tray.
To replace a BlackDiamond 12802 fan tray, you need the following tools and equipment:
● ESD-preventive wrist strap
● #2 Phillips screwdriver
● Replacement BlackDiamond fan tray
Removing the BlackDiamond 12802 Fan Tray
To remove the BlackDiamond 12802 fan tray:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top right corner of the switch.
2 Locate the captive screws at the top and bottom of the fan tray ( Figure 79 ).
3 Using a #2 Phillips screwdriver, loosen the screws until they are free of the switch back panel (see
Figure 79 ).
Figure 79: Removing the Fan Tray from the BlackDiamond 12802 Switch
4 Use the fan tray handle to pull the fan tray half-way out of the fan tray slot (see Figure 79 ). This
action disconnects the fan tray from the switch power.
Wait for the fan blades to stop turning before continuing with this procedure.
WARNING!
Be sure that all fan blade motion has ceased before continuing to remove the fan tray.
5 Support the bottom of the fan tray with your free hand as you use the handle to slide the fan tray
completely out of the fan tray slot.
CAUTION
Use both hands to support the weight of the fan tray during removal.
BD_145