Extreme Networks BlackDiamond 12804 - Manual (Page 84)

Installing Power Supply Units
BlackDiamond 12800 Series Switches Hardware Installation Guide 84
Front Panel LEDs
The front panel of the Extreme Networks 700/1200 W AC PSU provides status LEDs. Table 18 describes
the LED behavior on the front panel.
Table 18: Extreme Networks 700/1200 W AC PSU LEDs
Power Supply Cords
Extreme Networks 700/1200 W AC PSU(s) come with both 110 V AC and 220 V AC power supply
cords. The 110 V AC power supply cord allows for a maximum DC output power of 700 W. The 220V
AC power supply cord allows for a maximum DC output power of 1200 W.
CAUTION
All power supply cords provided by Extreme Networks are designed for use in North America only. Power supply
cords for use outside of North America are typically provided by a third-party distribution center and must meet the
following requirements:
● Power supply cords must be agency certified for country of use.
● Power supply cords must contain an IEC 320 C13 connector on the end of the PSU.
● Power supply cords must contain an appropriately rated and approved wall plug applicable to the
country of installation.
● Power supply cords must be less than 5 m long.
● Wire size must be a minimum of 16 AWG (1.0 mm 2 ) copper-stranded.
WARNING!
Always be sure that the source outlet is properly grounded before plugging the AC power cord into the Extreme
Networks 700/1200 W AC PSU.
PSU Condition
Power
Green Predictive Fail
Amber Fail
Amber
Power supply AC outputs working normally On Off Off
AC input power present/standby output on Blinking Off Off
Current limit on 48 VDC output On Off Blinking
Predictive failure On Blinking Off
No input power to this PSU only Off Off On
No input power to any PSU Off Off Off
Power supply failure Off Off On