Grass Valley iControlEdge v.1.20 ReadMeFirst - Manual

iControl Edge Version 1.20
READ ME FIRST
iControl Edge enables television service providers to cost-effectively monitor hundreds of television signals spread across
multiple remote locations, using remotely controlled set-top-boxes, DVRs, and receiver/decoders. It consists of a suite of
existing Miranda products and third-party devices that have been specifically packaged into an “off-the-shelf” monitoring
solution.
At each remote head-end, set-top box signals are fed into Densité control probes or into an Allegro-1-Analog
encoder/server. The signals are then streamed back to the Network Operations Center’s iControl Edge monitoring system.
Each device (Application Servers, Allégro frames, Densité frames and cards, Global Caché GC-100 network adapters, etc.)
ships with its standard documentation. However, note that some of the constituent products may have features that are not
supported in the context of iControl Edge.
Your primary references for deploying and operating your system are the
iControl Edge Installation & Setup Guide (Part
number: M867-0602-101) and the iControl Edge Operator’s Overview (Part number: M867-0700-101). If you cannot find
these documents after following the pre-installation instructions (see page 3), please contact [email protected].
Part Number: M867-0500-101 11 November 2009