Grass Valley JEP Series v.1.3.0 - Manual (Page 79)

JEP Series — Installation Manual 79
SelAMod. - Select Audio Mode (Special Stereo Switching)
The JEP-100 can provide stereo switching modes, which are Normal, Left,
Right, Mix, and Reverse. These changes are made to individual levels prior
to completing a switch.
Note Audio mode will only appear in the Preset window if a Venus or Apex router
is connected and configured for special stereo switching. In particular, the
Jupiter Switcher Description table must define Left and Right levels in the
Audio column. For more information, refer to either the Jupiter CM-4000 or
CM-4400 manual.
To perform a special stereo switch:
1. SOURCE - ON.
2. Use the UP/DOWN buttons to select the new input.
3. Press MENU .
4. Use UP/DOWN to display "SelAMod?" meaning that this is the mode that
will be selected if the TAKE button is pressed.
5. Press the TAKE button.
The Preset window will display "Pair 1," referring to the first two audio
levels listed in the Jupiter CP Level Set; e.g., Left and Right.
6. If this is the preferred pair, press the TAKE button. If not, use UP/DOWN to
select the appropriate audio pair, and then press the TAKE button.
The current audio mode for the selected pair will be shown.
A maximum of four audio pairs can be defined.
7. Toggle to the preferred mode: