Grass Valley K2 Dyno Quick Start v.1.6 - Manual (Page 13)

13 April 2010 K2 Dyno Replay System Quick Start Guide 13
Chapter
2
Operation
Start a new session
Prerequisite: Dyno Server software must be installed on the K2 Summit/Solo. On the
K2 Summit Production Client that you receive with the K2 Dyno Replay System
(Dyno-Pack), it is pre-installed.
In approximately one minute the K2 Dyno Replay application should appear on the
touch screen and on the VGA screen.
Loop record can be set when you configure a Dyno session, and cannot be changed
during the active recording session. Exporting HL clips and Playlists is best done in
regular record mode (loop record off).
K2 Repla
y
Client
ay
K2 Repla
y
Client
On the K2 Dyno Replay Controller, open K2 Replay Client 1
Select
Configure 2
Select the K2 Summit
Client and Next 3
Select a new session
and Next 4
Set C1 and C2 to Recorder,
C3 and C4 to Player and
Next 5
Set C3 to PGM, C4 to
PVW and Start 6