Grass Valley K2 Dyno Service Manual User Manual
K2 dyno
Advertising
Table of contents
Document Outline
- Safety Summaries
- Finding Information
- Product Description
- Service Procedures
- Troubleshooting problems
- Step 1: Check configurations
- Step 2: Check connections and external equipment
- Step 3: Identify problems using the startup sequence
- Step 4: Run hardware diagnostics
- BIOS startup information
- Shutdown/restart problems
- Checking external equipment
- BIOS startup
- BIOS POST error messages
- Windows startup
- LCD screen problems
- Thermal problems
- Power supply problems
- Isolating functional problems
- Removing and replacing FRUs
- Job knob removal
- Control panel UI board identification
- Job knob bearing assembly removal
- Job knob replacement
- T-bar lever handle removal
- Compact Flash boot media removal
- Top removal
- Top unit cable removal Type I control panel UI board
- Top unit cable removal Type II control panel UI board
- Top replacement
- T-bar lever assembly removal
- Plastic cover removal
- LCD screen inverter board removal
- Type I control panel UI board removal
- Type II control panel UI board removal
- Type II encoder removal
- LCD screen removal
- Front I/O board removal
- Fan removal
- Motherboard removal
- Cabling diagram with Type I control panel UI board
- Cabling diagram with Type II control panel UI board
- USB board removal
- Power supply removal
- Trademarks and Agreements
- Index