Epson 5000/5500 - Manual (Page 67)

Micro Feed
Adjusting the loading position
The loading position is the position of the paper after it has been
automatically loaded by the printer. If printing is too high or low
on the page, change the loading position with the micro-feed feature
as follows:
1. Make sure the printer is turned on.
2. Load either continuous or single-sheet paper. (Load continuous
paper by pressing the LOAD/EJECT button.) The MULTI-PART light
begins to blink.
Note: You can adjust the loading position only while the
MULTI-
PART light is blinking.
3. While holding down the
ALT
button, press the
LOAD/EJECT
button to adjust the loading position to a lower position on the
page; press
the LF/FF button to adjust the loading position to a
higher position on the page. The MULTI-PART light stops blinking
after a short time.
3-14 Using the Printer