EdgeStar CENELEC CW1200 - Manual (Page 10)

How To Operate Your Washer Dryer
Good Washing starts with hot water. To get your clothes clean and dry you need
hot water. Your washer dryer automatically heats the water in the wash cycle.
Select fabric type and program. Turn wash program knob to the
program number on the dial. Turn temperature knob to select
desired heat setting. Turn dryer knob to select time in minutes.
Press spin button to select 550 rpm or release for 1000 rpm.
Push start button. This program allows wash through dry automatically.
When drying is complete drum stops turning. Press stop button,
open door and take away laundry. The cool down feature towards
the end of drying cycle prevents creases & wrinkles.
Choose the dry settings to fold and put away your clothes immediately.
In this program drying capacity must not exceed 6 lbs.
Select fabric type and program. Turn wash program knob to the
program number required. Turn temperature number to the desired
heat setting. Turn dryer knob to off position. Press start button.
Turn wash program knob to dry cycle position. Turn dryer knob
to select time in minutes. Press Spin button to select 550 rpm
or release for 1000 rpm. Press start button.
Refer drying table to determine the correct time.
Alwais remember that time to dry varies by dampness and fabric type.
Your dryer is constructed to deliver dry laundry that can be folded
and put away immediately.
Select fabric type and program. Turn wash program knob to the
program number required. Turn temperature number to the
desired heat setting. Turn dryer knob to of position.
Press the No Spin button. Press the Start button.
In this program the machine skips spin cycle. It is meant for
stopping the machine after rinse and drain. Use this button for
delicate fabrics where the clothing label does not recommend
spinning. Do not press No spin button in Automatic program,
or the dryer will not turn on.
Select fabric type and program. Turn wash program knob to the
program number required. Turn temperature number to the
desired heat setting. Turn dryer knob to the off position.
Press the Rinse Hold button. Press start button.
This program is meant for pausing the machine after rinse without
draining. In this program the machine stops after the last rinse
with drum full of water. Press stop button, open the door and
take out your laundry. Some fabrics need to be drip dried.
Refer clothing label to identify such fabrics.
Do not press the Rinse Hold button in Automatic Program, or the
dryer will not turn on.
Select fabric type and program. Turn wash program knob to the
program number required. Turn temperature number to the
desired heat setting. Turn dryer knob to the off position.
Press Super Rinse button. Press the Start button.
Press stop button at the end of the cycle to remove laundry.
In this program the machine runs a super rinse on your laundry.
Do not press Super Rinse button in Automatic program, or the
dryer will not turn on.
AUTOMATIC PROGRAM
WASH ONLY
TIME DRY ONLY
WASH ONLY - NO SPIN
WASH ONLY - RINSE HOLD
WASH ONLY - SUPER RINSE
Wash Program Start Temperature Dryer Timer Spin
Wash Program Temperature Dryer Timer Start
Wash Program Start Dryer Timer Spin
Wash Program Start Temperature Dryer Timer No Spin
Wash Program Start Temperature Dryer Timer Rinse Hold
Wash Program Start Temperature Dryer Timer Super Rinse
Page 10