Grass Valley Telecast Fiber Solutions - Manual (Page 7)

3
Using Fiber Optic Cable
This chapter covers useful information regarding the deployment and use of Fiber Optical
cable
Running the Fiber Cable 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Planning the Fiber Cable Route . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Running the Fiber Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Managing the Fiber Optic Cable
The deployment of Fiber Optic Cables will vary greatly among users. Where the Fiber Optic
cable is permanently installed between units, such as between a campus performance
venue and a central media center, the management of the fiber optic cable will be a one-
time occurrence. For those users who deploy the equipment in variable and outside
locations the considerations discussed below are important every time the Fiber Optic
Deployment system is used.
To prevent damaging your eyes, never look directly into the end of the optic fiber
while either end of the system is operating.
Always protect the ST Fiber Optic connectors when the cables are not connected. This
protects the connector from damage and the unlikely event of exposure to an operating
optical link. Keeping protection in place when the connectors are not in use will prevent
dirt and dust from entering the connector and degrading the performance of the optical
link.
It is important that you do an initial setup and test your system as soon as you receive it to
confirm proper operation and to provide training for you and your team prior to an actual
production.
It is highly recommended that you do not attempt to power up the system until all
connections are made. In particular, the Fiber Optic Cable must be connected at both ends.
If you need to power up the Fiber Optic Deployment unit, make sure that the Fiber
Connectors are protected. This will protect theconnector from damage or dirt and protects
you from damaging your eyes.
Deploying the Fiber Cable
Successful connection and management of the Fiber Cable requires you to perform four
tasks:
• Plan the route the Fiber Cable will take to the units
• Run the Fiber Cable along the planned route
• Connect the Fiber Cable Connectors at each end
• Power up the device and check the Fiber Optic Cable Links by means of the LED display
(where applicable).