Grass Valley PLSDST3 - Manual (Page 10)

DST 312/412 Interface Kit Installation
4 DST 312/412 Interface Kit Installation
Preparing the Profile Video File Server
Installing RAM on the Master or Slave EDR board and installing a SCSI adapter
board requires opening the Profile video file server and removing the circuit board
hold-down brackets. Use the procedures that follow to prepare the Profile video
file server for RAM and SCSI adapter installations.
1. Loosen the front panel retaining screw and pull the cabinet out until all three
slide sections latch.
2. Remove the top covers in the order shown in Figure 1. The front cover must
be removed first since it overlaps the rear cover. Use T-10 and T-15 TORX
drivers to remove the screws.
NOTE: Take care not to lose these cabinet screws. They are required to meet
the EMI specifications for the Profile video file server.
Figure 1. Removing the top covers
9675-9
2
1