Grass Valley DVCPRO Board Upgrade - Manual (Page 20)

DVCPRO Board Installation
20 DVCPRO Upgrade Installation
Removing the Chassis Covers
To remove the chassis covers from the Profile unit:
NOTE: The front chassis cover must be removed first because it overlaps the
rear cover.
1. Turn Profile system power off and remove the power cord.
2. Loosen the front panel retaining screw and pull the chassis out from the rack
until the slide sections latch. If the rack is not anchored firmly, remove the
chassis from the rack (see the instructions under “Removing the Profile Unit
from the Rack” on page 18).
3. Use the Torx tool with the T10 tip to remove the top screws from the front
chassis cover (
Ê in Figure 2) and use the T15 tip to remove the pan-headed
side screws. Set cover aside.
NOTE: Store the chassis screws in a container so that you do not lose them.
They must all be reinstalled as they are required to meet the EMI
specifications for the video file server.
4. Use the Torx tool with the T10 tip to remove the rear chassis cover (
Ë
in
Figure 2). Set the cover aside.