Emerson Radio iP550 - Manual (Page 16)

15
5.) When the correct time appears on the display press the Time/Display button
once more to enter the time and start the clock running.
The Minute digits stop flashing and
only the colon (:) continues to flash
once per second to confirm that the
clock is running.
NOTES:
After pressing the Time/Display button you must press the ( ) or ( )
buttons within 10 seconds while the display is flashing or the time cannot be
adjusted.
If the display backlighting goes off and the display stops flashing before you
can set the time, repeat the above clock setting procedure and make sure that
you adjust the time within 10 seconds after pressing the Time/Display button.
The correct time will appear on the display when the system is in the power ‘Off’
mode, the iPod mode, or the AUX mode.
When the system is in the RADIO mode the display will show the AM or FM
frequency of the radio station you selected. To see the time in the RADIO mode,
press the Time/Display button once. The display will change from radio frequency
to correct time for 5 seconds, and then back to radio frequency automatically.
iP550_041907.p65 19/4/2007, 17:56 15