Grass Valley TTN-BRS-3232 - Manual (Page 11)

BRS-3232 Rev. 1
3
2. Power connection
Do not connect mains to the desktop power supply before connecting the power supply to the
router.
Connect the DB9 female connector from the desktop power supply to the main unit. Tighten the screws to
assure a proper contact. To connect mains to the desktop power supply you need a mains cord with IEC
320 connector.
The BRS-3232 is normally delivered with the desktop power model AC ±5V / 30W. Upon customer
request, BRS-3232 can also be delivered with DC ±5V / 30W, which may be fed by a 36 – 72 VDC mains
power source. A Frame mounted power supply solution is also available.
Please refer to the latest Triton Product Catalogue for power supply types, or call Thomson Grass Valley
for this information.
If any third party power supply is used the BRS-1616 router requires +5V DC with a minimum current of
800mA. The following pin-out is used on the DB9 male power connector:
Pin 1 0V
Pin 2 +5V
3. Connecting the BRS-3232 to your PC
For connection to a PC with Triton - Router Control System, the RS-232 interface is used. The RS-232
port on all Triton devices uses the standard DCE pin-out, see pin-out table under 4.3.
A standard modem cable can be used for connecting the router to the PCs serial port.
3.1. Selection of router level
The router level depends on the system configuration the router is going to work with. See chapter 5 for
more information. All routers are delivered with default level 1. Triton - Router Control System offers the
control of up to 16 different routers or combinations of routers.
3.2. Pin-out of RS-232 connector
The DB9 female connector for the RS-232 port has the following pin-out:
Pin 2 Tx
Pin 3 Rx
Pin 5 GND
3.3. Maximum cable length
The maximum cable length for an RS-232 connection is per definition 15m. Longer distances can be
installed depending on the environmental conditions of the installation site. It is the responsibility of the
installer / user to secure a proper installation of the RS-232 connection.