Grass Valley TTN-CP-32GPI - Manual (Page 16)

CP-32GPI Rev. 3
10
* - - - - * 34
* - - - * - 35
* - - - * * 36
* - - * - - 37
* - - * - * 38
* - - * * - 39
* - - * * * 40
* - * - - - 41
* - * - - * 42
* - * - * - 43
* - * - * * 44
* - * * - - 45
* - * * - * 46
* - * * * - 47
* - * * * * 48
* * - - - - 49
* * - - - * 50
* * - - * - 51
* * - - * * 52
* * - * - - 53
* * - * - * 54
* * - * * - 55
* * - * * * 56
* * * - - - 57
* * * - - * 58
* * * - * - 59
* * * - * * 60
* * * * - - 61
* * * * - * 62
* * * * * - 63
* * * * * * 64
5.3 Programming of restrictions
If the Restrictions option is enabled by the user, the previously programmed restrictions will be fetched
from the on-board memory during power-up. New restrictions may be programmed by putting the panel
in “Programming mode”. This is done, starting from Panel Disable state, by pushing and holding “V/A
toggle”, “Take On/Off” and “Take” and then pushing “Panel Enable”. Programming mode is indicated by
blinking “Panel Enable” and “Take”.
All the legal inputs for the selected output are shown by orange light in button. The Legal/Illegal toggle is
done by pushing the appropriate input button. When a new output is selected, the programming of the
previous output is saved in the on-board memory and the old setting of the new output is fetched from the
on-board memory.
After all necessary programming is done, the programming mode is stopped by pushing Panel Disable.
Disabling an output completely is done by disabling all inputs for the given output. When in normal mode
these outputs may be selected for viewing the status, but not controlled.