E&J GF0600059REVB06 - Manual (Page 19)

Metro Power III Owner’s Manual GF0600059RevB06, November 2006 19
adjust elevating legrest footplate extension length
7 / 32 " hex key
To adjust footplate extension length, you will loosen the clamp that holds the footplate extension
inside the legrest hanger.
1. Loosen legrest hanger clamp: use a
7 /
32
"
hex key to loosen clamp enough so that
footplate extension tube slides inside
legrest hanger tube.
2. Reposition footplate extension in desired
position.
3. Tighten legrest hanger clamp: use a 7 /
32
"
hex key to resecure clamp.
4. Follow steps 1-3 to adjust other footplate.
5. Ensure that both clamps are securely
fastened and that minimum ground clear-
ance is 2 1 / 2
inches.
adjust elevating legrest pad
position up or down
The legrest pad has three possible posi-
tions, adjustable in one-inch increments.
To adjust:
1. Rotate pad/hinge plate assembly on
legrest tube so that legrest tube stop
is in center of hinge plate slot.
2. Slide pad/hinge plate assembly up or
down legrest tube to desired posi-
tion.
3. Rotate pad/hinge plate assembly on
legrest tube so that legrest tube stop
is aligned in desired position.
elevating legrest
(footplate extension
not shown)
leg panel
hinge plate slot
legrest tube stop
legrest tube
pad/
hinge plate assembly
adjust legrest
footplate extension
length (left shown)
clamp
footplate
extension
tube
legrest hanger
tube