Echo CS-8000 TYPE1-E - Manual (Page 27)

25 CS-8000 TYPE1-E
GUIDE BAR
s
- Clean the groove of the guide bar with a small
screwdriver.
- Clean oil holes with a wire.
s
mount area before installation of the bar.
Replace either or both if worn.
SPROCKET
s
damage or wear of saw chain.
- When the sprocket has worn out 0.5 mm (0.02
in.) or more, replace it.
s
Replace it if worn.
CYLINDER FINS
s
cooling air pass easily.
MUFFLER SPARK ARRESTOR
s
plug lead.
s
cover and screen from muffler body.
s
burned through.
s
NOTICE
Carbon deposits in muffler will cause drop in
engine output. Spark arrestor screen must be
checked periodically.
AUTOMATIC OILER
s
adjusted to 8 mL/min approximately at 7000
r/min, prior to shipment from factory.
- To increase the delivery volume, turn the
adjusting knob clockwise.
When the knob touches stopper and stops,
this position indicates maximum discharge
volume. (15 mL/min at 7000 r/min)
- Do not turn the adjusting knob beyond the
maximum or minimum limit of volume
adjustment.
Worn : 0.5 mm (0.02 in.)
Groove
Oil hole
Cylinder fins
Spark arrestor screen
Muffler
Screen cover
Clutch
(Sprocket)
Decrease Increase
Adjusting knob
Exhaust guide