Operation, Starting the engine, Stopping the engine – Polaris 2015 Ranger Diesel / Crew Diesel User Manual

Page 45: Braking

Advertising
background image

43

OPERATION

Starting the Engine

NOTICE: NEVER use an engine starting aid such as ether. Engine

damage will result.

Before operating this vehicle in cold weather, review the cold

weather operation information beginning on page 40.

Always wait for the glow plug indicator light to turn off

before cranking the engine.
1. Always start the engine outdoors or in a well-ventilated

area.

2. Sit in the driver's seat and fasten the seat belt. Secure the

cab nets (or doors).

3. Place the transmission in PARK.
4. Apply the brakes. Do not press the throttle pedal while starting the engine.
5. Turn the ignition switch to the ON position and wait for the glow plug indicator light to

turn off.

6. Turn the ignition key past the ON/RUN position to START. Engage the starter for a

maximum of five seconds. Release the key when the engine starts.

7. If the engine does not start within five seconds, release the ignition switch and wait five

seconds. Repeat steps 6 and 7 until the engine starts.

NOTICE: Operating the vehicle immediately after starting could cause engine damage. Allow the

engine to warm up for several minutes before operating the vehicle.

Stopping the Engine

For maximum engine life, allow the engine to idle, without load, for 5 minutes. This will

allow the engine components that operate at high temperatures, such as the exhaust system,

to cool slightly before the engine is shut down.
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in PARK.
3. Turn the engine off and remove the key to prevent unauthorized use.

WARNING! A rolling vehicle can cause serious injury. Always place the transmission in PARK when
stopping the engine.

Braking

1. Release the throttle pedal completely.

Tip: When the throttle pedal is released completely and the engine speed drops near an idle, the

vehicle has no engine braking.

2. Press on the brake pedal evenly and firmly.

Tip: If the throttle pedal and brake pedal are applied simultaneously, engine power may be limited.

3. Practice starting and stopping (using the brakes) until you're familiar with the controls.

START

HELP

Advertising