Electrolux Blast Chiller/Freezer 10 GN2/1 - Manual (Page 2)

Electrolux Blast Freezers
Blast Chiller/ Freezer - 56 kg 10 GN2/1
Internet: http://www.electrolux.com/foodservice
HDBA040
2011-06-10
Subject to change without notice
SLIDE-IN RACK SUPP. BC+BCF 56KG 10 GN2/1 880075
PRINTER HACCP BASIC VERS-REF.ELECR.CONTR 881532
PLASTIFIED GRILL RILSAN GN 2/1 881030
PLASTIC COATED GRID-600X400 MM 880864
KIT TO CONVERT TO 10X2/1 ROLL-IN RACK 922202
KIT HACCP ADVANCED CONNECT. BC/BCF LW+CW 880183
80 MM PITCH SIDE HANGERS FOR 10X2/1 OVEN 922117
60 MM PITCH SIDE HANGERS FOR 10X2/1 OVEN 922123
4 WHEELS FOR BLAST CHILLERS 881097
3-POINT-SENSOR PROBE-BL.C/FREEZERS LW 880212
ACCESSORIES
1 SINGLE-SENSOR PROBE-BL.C/FREEZERS LW 1
INCLUDED ACCESSORIES
Power supply - V, phases, Hz 400 V, 3N, 50
Net weight - kg. 235
installed-electric 2.88
Power - kW
at evaporation temperature - °C -30
Refrigerant power
Refrigeration power - W 2540
Refrigerant quantity - g. 3170
Refrigerant type R404a
N° defrost in 24 hrs. 3/30'
Compressor power - HP 3
Max load capacity - trays h 65 mm - n° 6
Trays type GN 2/1; 600x800
Door hinges Right Side
height 1640
depth/with open doors 1010, 1755
width 1000
External dimensions - mm
Cooling unit Built-In
Gross capacity (D.I.N. 8952) - l. 560
UK Guide lines - chilling / freezing 64, 56
NF Regulations - chilling / freezing 43.2, 43.2
Productivity per cycle - kg.
Power supply Electric
TECHNICAL DATA
RBC102
726046
CONSTRUCTION
• Internal and external finishing in 304
AISI stainless steel and backpanel in
galvanized steel.
• High density polyurethane
insulation, 60 mm tickness, HCFC
free.
• Environmentally friendly: R404a as
refrigerant fluid.
• Developed and produced in ISO
9001 and ISO 14001 certified factory.
• Inner cell with fully rounded corners.
• Door equipped with removable
magnetic gasket with hygienic design.
• Motors and fan waterproof
protected IP23.
• Evaporator with antirust protection.
• Ventilator (fan) swinging hinged
panel for access to the evaporator for
cleaning.
• Automatic heated door frame.
• Thermostatic expansion valve to
optimize the cooling unit efficiency.
• Adjustable feet 150 mm high.
• Stand alone printer as accessory.
• PC connection on request, gate RS
485.
INSTALLATION
• No water connections required.
• Waste water can be plumbed into
drain, but can also be collected in an
optional waste container.