HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 34)

33
Milling cycles
Groove axial
Groove radial
This cycle creates a groove on the end face/lateral surface of a
workpiece. The groove width equals the cutter diameter.
Information on the cycle parameters:
C:
Spindle angle (C-axis position) – default: current spindle angle
Z1/X1: Upper edge of milling – default: Start point Z/X
Z2/X2: Lower edge of milling
P: Plunging depth – default: total depth in one infeed
FZ: Infeed – default: active feed rate
Groove axial
Rapid traverse positioning
This cycle switches on the C axis, and positions the spindle (C axis) and
the tool.
Information on the cycle parameters:
X2, Z2:
End point
C2: Final angle
• A subsequent manual milling cycle switches off the C axis.
• “Rapid traverse positioning“ is is only required in the Manual
mode.