HEIDENHAIN TNC 320 (34055x-06) Cycle programming - Manual (Page 307)

DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413) 15.7
15
TNC 320 | User's Manual Cycle Programming | 5/2013
307
New datum in TS axis Q333 (absolute): Coordinate
in the touch probe axis at which the TNC should
set the datum. Default setting = 0. Input range
-99999.9999 to 99999.9999
No. of measuring points (4/3) Q423: Specify
whether the TNC should measure the stud with 4 or
3 probing points:
4 : Use 4 measuring points (default setting)
3 : Use 3 measuring points
Type of traverse? Line=0/Arc=1 Q365: Definition
of the path function with which the tool is to move
between the measuring points if "traverse to
clearance height" (Q301=1) is active:
0 : Move in a straight line between machining
operations
1 : Move in a circular arc on the pitch circle diameter
between machining operations