HEIDENHAIN TNC 620 (340 56x-03) Cycle programming - Manual (Page 372)

372 Touch Probe Cycles: Automatic Workpiece Inspection
16.2 REF
. PLANE (Cy
c
le 0, DIN/ISO: G55)
16.2 REF. PLANE (Cycle 0, DIN/ISO:
G55)
Cycle run
1 The touch probe moves at rapid traverse (value from FMAX
column) to the starting position
1 programmed in the cycle.
2 Then the touch probe runs the probing process at the probing feed
rate (column F). The probing direction is to be defined in the cycle.
3 After the TNC has saved the position, the probe retracts to the
starting point and saves the measured coordinate in a Q
parameter. The TNC also stores the coordinates of the touch probe
position at the time of the triggering signal in the parameters Q115
to Q119. For the values in these parameters the TNC does not
account for the stylus length and radius.
Please note while programming:
Cycle parameters
8 Parameter number for result: Enter the number of
the Q parameter to which you want to assign the
coordinate. Input range 0 to 1999
8 Probing axis/Probing direction: Enter the probing
axis with the axis selection keys or ASCII keyboard
and the algebraic sign for the probing direction.
Confirm your entry with the ENT key. Input range: All
NC axes
8 Nominal position value: Use the axis selection keys
or the ASCII keyboard to enter all coordinates of the
nominal pre-positioning point values for the touch
probe. Input range -99999.9999 to 99999.9999
8 To conclude the input, press the ENT key.
X
Z
1
Danger of collision!
Pre-position the touch probe in order to avoid a collision
when the programmed pre-positioning point is
approached.
Example: NC blocks
67 TCH PROBE 0.0 REF. PLANE Q5 X-
68 TCH PROBE 0.1 X+5 Y+0 Z-5