EdgeStar KC2000SSTWIN - Manual (Page 4)

Install and Secure the Tower
1. Remove the plastic plug from the top of the cabinet by opening the door and pushing up.
2. Place the rubber gasket on the cabinet and align the holes. (Note: Some models may
require you drill holes on the top of the unit.)
3. Unravel the beer line from the inside of the tower and pass it through the rubber gasket
and the hole on the top of the beer refrigerator.
4. Place the tower facing forward and insert the bolts through top of the cabinet.
5. Insert a washer through a bolt and fasten a hex nut. Repeat the process for all bolts.
Drilling holes on the top of the cabinet (If necessary)
5 1/8”
5 1/8”
Back of Unit
Rubber Gasket
1. Use the rubber gasket as a template to mark the holes. Center the gasket over the
center hole. The rear holes need to be 5 1/8
th
from the back of the unit. Mark the holes with
a marker.
2. Remove the gasket, then use a 13/64
th
” drill bit to drill the holes.