ShoreLand'r SLR95TAL - Manual (Page 11)

SD Control Module Mounting Instructions:
Locate the SD control module. Position the SD control module so the mounting holes in it align
with the holes pre-drilled in the side frame. Secure the SD control module to the side frame
with two- 1/4” x 1” carriage bolts and hex nuts. Tighten.
Batteries:
1. Place the batteries in the battery boxes. Remove the protective covers from the battery
terminals.
Locate the battery wire harness supplied in the kit. Connect it to the batteries by connecting
the wire harness spades with the red coating to the positive post and the white or black wire to
the negative post of the battery.
2. Route the wire harness from one battery to the other and then over to the SD control
module. Place on the battery box covers.
3. Attach the battery wire harness to the mating molded plug of the SD control module. Snap
together to hold in place.
Electric over Hydraulic Actuator Installation:
1. Locate the brake actuator Place one each 5/16” lock washer on the three 5/16” x 1” hex
bolts. Attach the brake actuator to the actuator offset bracket with three 5/16” x 1” hex bolts.
Tighten. Attach this assembly to the side frame with four 1/4" x 1" hex bolt and lock nuts.
Tighten.
Note that the SD control module should be located between the hydraulic actuator and the
front of the trailer frame.
2. Snap the mating plugs from the wire harness to the respective mating plugs from both the
SD control box and the actuator according to the instructions provided with the electric over
hydraulic kit. See the wiring schematic on page 20 of the manual provided with the actuator.
Make sure they are completely snapped together and locked to assure a positive connection.
Brake Line Tubing Connection:
1. Locate the brake hose installed at the factory and is routed to the newly installed actuator.
2. Route the hose with smooth round curves over to the port in the actuator.
3. Thread the brass brake line elbow fitting into the actuator port if not already installed.
4. Thread the frame brake hose into the brass elbow in the port of the actuator shown. Tighten.
Filling the System with Brake Fluid:
Fill the reservoir on the actuator with an Arctic-SAEJ1702 or SAEJ1703 brake fluid or a fluid
that is comparable. Remove one of the reservoir caps located on the actuator. Only one cap
has to be removed. Add fluid until the reservoir is full. Bleed the brake system following the
procedure for bleeding the brakes. It may be necessary to add fluid to the reservoir during the
Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004307
Page 11 of 16 2/24/2011