ShoreLand'r SLB40TABBXLW - Manual (Page 12)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003726
Page 12 11/28/06
B-SERIES BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the
bunk mounting brackets are assembled to the bunks
at the factory. Place the end with the two brackets to-
wards the rear of the trailer. Place the assembly on the
equiload bunk arm and secure by placing a 3/8” x 1”
hex bolt through the bracket on the bunk and the ear
on the end of the equiload arm.
Secure in place using a 3/8” lock nut. Repeat on the
other end of the arm. (See Diagram A).
Place the other end of the bunk in the bracket installed
on the front cross member. Note that this bracket is
not attached to the bunk because the trailer can be ad-
justed to two different lengths. Once the proper posi-
tion for the rear crossmember is determined, the front
of the bunk can now be attached to the bracket using
two- No. 10 x 1-1/4” self tapping screws as shown in
Detail D.
The 3/8” x 1” bolts attaching the bunks to the equiload
arms and front bunk bracket can be tightened but not
over tightened.
The bunks must be allowed to rotate slightly to con-
form to the boat bottom once the boat is set on the
trailer.