ShoreLand'r SL40TBAL - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M301237
Page 4
B-SERIES BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the bunk
mounting brackets are assembled at the factory. Place the
end with the two brackets towards the rear of the trailer. Place
the assembly on the equiload bunk arm and secure by
placing a 3/8” x 1” hex bolt through the bracket on the bunk
and the ear on each end of the equiload arm. Secure in place
using a 3/8” lock nut. Repeat on the other end of the arm.
(See Detail H.)
The front bracket is not attached to the bunk because the
trailer can be adjusted to two different lengths. Once the
proper position for the rear cross member is determined, the
front of the bunk can now be attached to the bracket using
two- No. 10 x 1-1/4” self tapping screws as shown in Detail G.
The 3/8” bolts can be tightened but not over
tightened because the bunks should be allowed to rotate
slightly to conform to the boat’s bottom.
Tire And Wheel Assemblies
Mount the tire and wheel assemblies using the 1/2” fine
threaded tapered lug nuts provided. Tighten to 80-90 ft/lb. of
torque using the rotation pattern as shown in the Shore
Landr’s Owners Manual. Re-torque the lug nuts after 50
miles of driving and then periodically thereafter.