ShoreLand'r TA0142 - Manual

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003894
Page 1 10/17/07
ACCESSORY
TA0142
Ramp Kit for the PS6X12
The TA0142 rear tailgate is designed to fit the PS6x12 utility trailer.
It is shipped complete with all of the attaching hardware and steel
straps.
Installation Instructions
• Locate and remove the hardware bag from the rear tailgate.
Sort all items by size. Also remove the two steel straps.
• Position the rear tailgate as shown in the drawing. Align the
side tubes of the tailgate with the mounting brackets on the
rear of the trailer.
• Insert a 9/16” x 3 ¼” hex bolt through the outer hole in the
mounting bracket on the trailer frame and then through the
rear tailgate as shown in the assembly view on page
2. Push completely through the hole on the inside of the
mounting bracket.
• Secure in place with a 9/16” hex lock nut.
• Repeat the above two steps on the other end of the rear tail-
gate.
• Once both bolts and nuts are installed, tighten the nuts until
a minimum of two threads are exposed through the nuts. The
nuts can be tightened farther is desired making sure they are
not overtightened. The rear tailgate must be allowed to tilt.
• Locate the two metal straps. Align the hole in one end of the
steel straps with the attaching pin welded to the side frame
as shown in the assembly view on page 2. Slide the steel
strap onto the pin and secure in place using the 3/16” x 1 ¼”
lynch pins.
• Rotate the rear tailgate up into the transport position. Align