EVGA NFORCE 650I - Manual (Page 26)

Hardware Installation
15
Connecting Cables and
Setting Switches
This section takes you through all the connections and switch settings necessary
on the motherboard. This will include:
‰ Power Connections
¾ 24-pin ATX power ( PWR1 )
¾ 8-pin ATX 12V power ( PWR2 )
‰ Internal Headers
¾ Front panel
¾ USB Headers
¾ Audio
¾ COM
‰ FDD
‰ IDE
‰ Serial ATA II
‰ Chassis Fans
‰ Rear panel USB 2.0 Adapter
‰ Expansion slots
‰ CMOS jumper settings
See Figure 1 on page 9 to locate the connectors and jumpers referenced in the
following procedure.