Yaskawa V1000 Option - DI-100 120 Vac Interface - Manual (Page 20)

5 Installation Procedure
20 YASKAWA ELECTRIC TOEP YEAOPT 03 - V1000 Option DI-100 120 Vac Interface Installation Manual
10. Reinstall the front cover(s). NOTE: Cover installation is model dependant.
Use Table 5 and associated figures as a guide to determine which drive models prohibit
bottom cover/conduit bracket reinstallation.
Table 5 Drive Cover Installation
NOTICE: Some V1000 models will not allow the bottom conduit covers to be reinstalled. Discard covers
specified in Figures 11 thru 15 after DI-100 installation is complete.
Figure 10
Figure 11 Cover Installation on Models
CIMR-VUBA0001 thru BA0003
CIMR-VU2A0001 thru 2A0006
Drive Models See Figure Model Notes
CIMR-VUBA0001 ~BA0003
CIMR-VU2A0001 ~2A0006
IP20/Open
IP20/NEMA Type 1
Figure 11
1-phase 200 V
and 3-phase 200 V
(small frame) <1>
<1> Because the bottom cover/conduit bracket is discarded for DI-100 installation, the enclosure rating of these
models becomes IP00 or NEMA Open Type after DI-100 option installation.
CIMR-VUBA0006 thru BA0018
CIMR-VU2A0010 thru 2A0020
CIMR-VU4A0001 thru 4A0011
IP20/Open - Figure 12
IP20/NEMA Type 1- Figure 13
1- phase 200 V
3-phase 200/400 V
(medium frame) <1>
CIMR-VU2A0030 thru CIMR-VU2A0069
CIMR-VU4A0018 thru CIMR-VU4A0038
IP20/Open - Figure 14
IP20/NEMA Type 1 - Figure 15
3-phase 200/400 V
(large frame)
REMOVE and
discard this
cover
1
Reinstall
Note 1:
The drive enclosure rating
now becomes IP00/Open Type
with this cover removed.
IP20/Open Type NEMA Type 1
REMOVE and
discard these
covers
1
Note 1:
The drive enclosure rating
now becomes IP00/Open Type
with this cover removed.
Reinstall