Electrolux 506030 - Manual (Page 16)

18
D4 END OF WORK AND DAILY CLEANING
The appliance is designed to carry out an automatic
cleaning cycle to help flush out any residues and to
guarantee greater health and hygiene:
• Open the door and take out the rack containing the
clean pans.
• Remove the tank filters “C”-”D”-”E” and the overflow
“W” to drain the water from the tank (Figure 17).
Figure 17
• Close the door.
• Select the drain cycle by pressing “B” button
(Figure 12).
The message "CLE" ("CLEAN") will be displayed
throughout the drain cycle:
• After a few minutes, 3 beeps indicate the end of the
cleaning cycle and “END” blinks on the display:
• Switch off the potwasher by pressing “A” button
(Figure 12).
• Switch unit off at the main circuit breaker.
• Close the water shutoff valve.
• Replace the filters and the overflow.
Cleaning the nozzle jets
• Remove the top and bottom jets “F” and “I”,
unscrewing the ring nut “H”.
Figure 18
• Unscrew plugs “L” from the rinse jets and clean using
a water spray. Do not use sharp implements to clean
the nozzle holes, which could otherwise be damaged.
• Remove jet “P” (Figure 19) by turning it clockwise
and pulling it out.
• Unscrew plugs “R” (Figure 19) from the side jets.
Figure 19
• Clean all parts using a water spray. In particular, for
jet “P” use warm soapy water and a soft brush “Z” if
necessary (Figure 20). Do not use sharp implements
to clean nozzle holes.
Figure 20
W
C
D
E
H
F
I
L
P
R
R
P
Z
Z
Z
Z