Laney GS112VE - Manual (Page 3)

Laney
Dear Player,
Thank you very much for purchasing your new Laney product and becoming part of the worldwide Laney family. Each and every Laney unit
is designed and built with the utmost attention to care and detail, so I trust yours will give you many years of enjoyment.
Laney products have a heritage which stretches back to 1967 when I first began building valve amplifiers in my parent’s garage. Since then
we have moved on from strength to strength developing an extensive range of guitar, bass, public address and keyboard amplification
products along with a list of Laney endorsees that includes some of the world’s most famous and respected musicians. At the same time
we believe we have not lost sight of the reason Laney was founded in the first place - a dedication to building great sounding amplification
for working musicians.
Warm Regards,
Lyndon Laney CEO
Page 2/4
12
V
E
S
V
G
S1
G
21
0
E
INTRODUCTION
The GS112VE & GS210VE are a pair of 75W (8 Ohm) cabinets styled to accompany the VC range of amplifiers.
Featuring; robust plywood cabinet construction, side mounted handle, choice of either a single 12” or double 10” driver and stainless steel
corner protection. Whichever one of these cabinets you choose, it will augment the true vintage sound of your VC30 and add to its
versatility.
Every Laney product is extensively play tested by experienced guitarists to ensure it has the tone and durability to perform at the very
highest level, before being shipped to our customers.
Your GS112VE or GS210VE should give you years of trouble-free service, however please take time to read this manual, as it will allow you
to get the best from your extension cabinet. We hope you enjoy using your GS112VE or GS210VE as much as we enjoyed designing and
making it.
Best wishes from all at Laney.
Page3 /4
Duration Per Day
In Hours
8
6
4
3
2
1 ½
1
½
¼ or less
Sound Level dBA,
slow response
90
92
95
97
100
102
105
110
115
1). Read & Retain these Instructions carefully before installing or operating this product.
2). Comply with Warnings: All warnings and instructions for these products should be adhered to.
3). Unpacking: On unpacking your product please check carefully for any signs of damage that may
have occured whilst in transit from the Laney factory to your dealer. In the unlikely event that there
has been damage, please repack your unit in it original carton and consult your dealer. We strongly
advise you to keep your original transit carton, since in the unlikly event that your unit should develop
a fault, you will be able to return it to you dealer for rectification securely packed.
4). Amplifier Connection: In order to avoid damage , it is advisable to establish and follow a
pattern for turning on and off your system. With all system parts connected, turn on source
equipment, tape decks, cd players, mixers, effects processors etc, BEFORE turing on your guitar
amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers.
By turning on your guitar amplifier LAST and making sure its level control is set to a minimum, any
transients from other equipment should not reach your loud speakers. Wait till all system parts have
stabillised, usually a couple of seconds. Similarly when turning off your system always turn down the
level controls on your guitar amplifier and then turn off its power before turning off other equipment
5). Cables: Never use shielded or microphone cable for any speaker connections as this will not be
stubstantial enough to handle the amplifier load and could cause damage to your complete system.
6). Caution: These professional loudspeaker systems are capable of generating very high sound
pressure levels. Use care with placement and operation to avoid excessive levels that can cause
permament hearing damage.
7). Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary
considerably in susceptibility to noise induced hearing
loss, but nearly everyone will lose some hearing if
exposed to sufficiently intense noise for a sufficient
time. The U.S. Government's Occupational Safety and
Health Administration (OSHA) has specified the
permissible noise level exposure in the chart oposite.
According to OSHA, any exposure in excess of the
above permissible limits could result in some hearing
loss. Ear plugs or protectors in the ear canals or over
the ears must be worn when operating this
amplification system in order to prevent a permanent
hearing loss if exposure exceeds the limits set forth
oposite. To ensure against potentially dangerous
exposure to high sound pressure levels it is recommended that all persons exposed to equipment
capable of producing high sound pressure levels such as this amplification system be protected by
hearing protectors while this unit is in operation.
8). Servicing: The user should not attempt to service these products. Refer all servicing to qualified
service personnel
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
Laney
2V
E
S
V
G
S1
1
G
21
0
E
From amplifier
Extension Cab. Socket
Option if your
Amplifier supports
reduced impedance
Link out
to Input Socket
on another
Extension Cabinet
8 Ohms
Link Input
Designed in the UK by Laney
8 Ohms
Link
Designed in the UK by Laney
Input
SPECIFICATIONS GS210VE GS112VE
Impedance 8 Ohms 8 Ohms
Loudspeaker 2 x 10" Jensen C10Q16 1 x 12" Celestion 70/Eighty
Power Rating 75W RMS 75W RMS
Size W*D*H 562*253*423 562*253*423
Weight 16.5 Kg 16 Kg