Lanner FW-8760 - Manual (Page 34)

29
Bios Settings
Chapter 4
Network Application Platforms
USB Mass Storage Device Configuration
In this screen, you can configure the attached USB drive to
be used as the system’s hard drive.
USB Mass Storage Reset Delay
This option sets the reset timing for the USB Mass Storage
to be initialized.
Option Description
10 Sec When set to 10 Sec, the BIOS will wait for up to 10
seconds for the USB flash drive to initialize.
20 Sec When set to 10 Sec, the BIOS will wait for up to 20
seconds for the USB flash drive to initialize.
30 Sec When set to 10 Sec, the BIOS will wait for up to 30
seconds for the USB flash drive to initialize.
40 Sec When set to 10 Sec, the BIOS will wait for up to 40
seconds for the USB flash drive to initialize.
Emulation Type
USB Emulation refers the system being able to boot to
a USB drive. Normally if this option is not enabled, any
attached USB drive will not become available until a USB
compatible operating system is fully booted with all USB
drivers loaded. When this option is enabled, any attached
USB drive can boot the system even when there is no USB
drivers loaded on the system. Set this value to allow the
system to select the Emulation type for a USB drive.
Option Description
Auto Set this value to allow the system to automatically
detect a USB drive emulation type.
Floppy Set this value to allow the system to select floppy
emulation type.
Hard Disk
Drive Set this value to allow the system to select hard
disk drive emulation type.