Lanner FW-8893C - Manual (Page 11)

6
Introduction
Chapter 2
Network Application Platforms
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the FW-8893 and remove the power cord. 1.
Unscrew the 3 screws on left and right and two screws 2.
onthe back of the top cover.
Slide the cover backwards and open the cover.
3.
Installing the System Memory
The motherboard supports DDR3 memory to meet the
higher bandwidth requirements of the latest operating
system and Internet applications. It comes with Quad-
Channel DDR3 Dual Inline Memory Modules (DIMM)
sockets (a total of 16 DIMMs for 2 CPUs).
Open the DIMM slot latches. 1.
Install the DIMM. 2.
Note:
The motherboards can support up to 128 GB 1.
memory capacity in maximum.
The system support dual CPU configuration. If 2.
you have only one CPU, populate the DIMMs
close to the installed CPU socket
Since the system is capable of 3. Quad Channel
configuration, some installation guidelines have
to be followed to enable Quad Channel mode:
To insert 4 DIMMs on the system, insert DIMMS
into the 4 slots with black latches nearest to the
designated CPU socket (CPU socket No1 or No2).
And use slots with white latches if more slots are
required.
To activate Dual Channel instead of Quad 4.
Channel in the system, populate any 2 slots
with black latches nearest to the designated
CPU socket (CPU socket No1 or No2). And then
use slot(s) with white latch that belongs to the
same channel as the populated slot(s) for any
additional DIMMs.
Starting from the board edge (same for both CPU 5.
socket No1 and No2), one pair of black and white-
latched slots is configured as one channel.
1
2 1