Lanzar DCT202 - Manual (Page 4)

When Crossover Mode Selector is in
Low Pass Mode, this control limits the
frequencies which will be distributed to
the speakers to those below the value
to which this is set within the range
50 Hz - 500 Hz.
L OW P ASS F ILTER
When Crossover Mode Selector is in High Pass
Mode, this control limits the frequencies which will
be distributed to the speakers to those above the
value to which this is set within the range
50 Hz - 500 Hz.
H IGH P ASS F ILTER
Determines the mode of built-in crossover:
low pass(permits only low frequency signals to
pass to speakers), high pass (permits only high
frequency signals to pass to speakers), or flat.
C ROSSOVER M ODE S ELECTOR
Provide instant information on status of amplifier,
including short-circuit and thermal overload alerts.
P OWER & P ROTECTION I NDICATORS
Enables the matching of input
levels to the output levels from
the head unit(or other signal
source).
I NPUT L EVEL C ONTROL
Increases sound level in lower
frequencies by 18dB.
B ASS B OOST C ONTROL
I NPUT RCA J ACKS
These inputs are for signal
cables from the source.
Always use high quality
shielded RCA cables.
L INE O UT RCA J ACKS
The LINE OUT allows you to
build multiple amplifier systems
with out having to use splitter
cords to distribute the signal.
Now it is simple a matter of
bringing one set of RCAs into
the first amplifier, then using
the line out RCA jacks as the
feed to the next amplifier.
S PEAKER T ERMINAL.
20A x 2
25A x 2
25A x 3 DCT202
DCT252
DCT282
MODEL FUSES